Table of Contents
Advertisement
HART Loop Converter KFD2-HLC-(Ex)1.D(.**)
Editing device data: Parameterization mode
8.1.2 Password
You can protect the parameter settings from unauthorized changes using a password (see section 8.6,
inactive when HLC delivered).
If password protection is active, the various settings in parameterization mode can be viewed without
entering the password, but not changed.
The password cannot be changed and is 1234.
The password is entered as follows:
•
On the first attempt to make a change, the device immediately prompts for a password.
•
The first digit of the password flashes.
•
Now enter each number of the password by pressing the
OK to confirm each individual number. The next digit of the password then flashes.
•
You can abort password entry at any time by pressing ESC.
•
If you enter the last digit and press OK to confirm but the password is incorrect, the last digit of the
password continues to flash. You can either enter the last digit again or press ESC to cancel the
entry and make another attempt from the beginning.
•
If you enter the last digit, press OK to confirm and the password is correct, the parameter change
is accepted.
The password must be entered for each transition from display mode to parameterization mode, once
each time.
and
keys (numbers 0 to 9) and press
17
Advertisement
Table of Contents
