Replacing The Microprocessor - Lenovo ThinkCentre 0266 User Manual

Replacing the microprocessor

Attention: Do not open your computer or attempt any repair before reading and understanding the "Important
safety information" on page vii.
This section provides instructions on how to replace the microprocessor.
CAUTION:
The heat sink and microprocessor might be very hot. Turn off the computer and wait three to five
minutes to let the computer cool before removing the computer cover.
To replace the microprocessor, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Open the computer cover. See "Opening the computer cover" on page 28.
3. Locate the system board and disconnect all cables connected to the system board. See "Locating
parts on the system board" on page 10.
4. Press inward on the two side tabs and then pivot the system board to release it from the chassis.
Figure 23. Releasing the system board
5. Place the system board on a clean and flat surface.
6. Remove the heat sink. See "Replacing the heat sink" on page 37.
Note: Place the heat sink on its side so that the thermal grease on the bottom of it does not get in
contact with anything.
.
Chapter 5 Installing or replacing hardware
39