Sharpening Your Chain And Adjusting Raker Clearance - Husqvarna 323P4 Operator's Manual

Hide thumbs Also See for 323P4:
Table of Contents


Saw chain pitch (inches). (The distance between three
drive links, divided by two.)
Drive link width (mm/inches)
Number of drive links.
Sharpening your chain and adjusting raker
WARNING! The risk of kickback is increased
with a badly sharpened chain!
General information on sharpening cutting teeth
Never use a blunt chain. When the chain is blunt you have
to exert more pressure to force the bar through the wood
and the cuttings will be very small. If the chain is very blunt
it will not produce any cuttings at all. Wood powder would
be the only result.
A sharp chain eats its way through the wood and
produces long, thick cuttings.
The cutting part of the chain is called the cutting link and
this consists of a cutting tooth (A) and the raker lip (B). The
cutting depth is determined by the difference in height
between the two.
When you sharpen a cutting tooth there are five important
factors to remember.
- Filing angle
10 –
- Cutting angle
- File position
- Round file diameter
- File depth
It is very difficult to sharpen a chain correctly without the right
equipment. We recommend that you use our file gauge. This
will help you obtain the maximum kickback reduction and
cutting performance from your chain.
WARNING! The following faults will increase
the risk of kickback considerably:
File angle too large
Cutting angle too small
File diameter too small


Table of Contents

This manual is also suitable for:

325p5x series

Table of Contents