Charging The Battery - Motorola MC40 User Manual

Figure 6: Inserting the Battery
2 Lower the battery and press down until it snaps into place.
3 Press down on the battery latch.
4 Press the Power button to turn on the MC40.

Charging the Battery

Caution: Ensure that you follow the guidelines for battery safety described in
page 105.
Before using the MC40 for the first time, charge the main battery until the Right light emitting diode (LED) turns
solid green (see Table 5: Battery Charge LED Status on page 21
MC40, use a cable or a cradle with the appropriate power supply. For information about the accessories available for
the MC40, see Accessories on page
The MC40 is equipped with a memory backup battery that automatically charges from the fully-charged main battery.
When using the MC40 for the first time, the backup battery requires approximately 36 hours to fully charge. This is
also true any time the backup battery is discharged, which occurs when the main battery is removed for several hours.
The backup battery retains random access memory (RAM) data in memory for at least 10 minutes (at room
temperature) when the MC40's main battery is removed, when Battery Swap feature is used. When the MC40 reaches
a very low battery state, the combination of main battery and backup battery retains RAM data in memory for at least
48 hours.
For cable and cradle setup and charging procedures refer to the MC40 Integrator Guide.
• Micro USB Cable
• Single Slot Charging Cradle
• Five Slot Charge Only Cradle.
Table 5: Battery Charge LED Status
Status
Off
97.
Indications
MC40 is not charging.
MC40 is not inserted correctly in the cradle.
MC40 is not connected to a power source.
Charger or cradle is not powered.
Battery Safety Guidelines on
for charge status indications). To charge the
MN000111A04-A | July 2015
Getting Started | 21
Table continued...