Summary of Contents for Outback Power Systems FLEXware16 Amp Maximum 250VAC
Page 1
FLEXware16 Amp Maximum 30VDC/250VAC Rated Relay and DIN Mount Base with LED RELAY SIDE VIEW The FLEXware Relay Assembly will activate a two-wire start generator when wired to the AUX output of either an OutBack FX Inverter/Charger or an OutBack Charge Controller. The assembly consists of an LED module and a relay inserted (in one orientation) into a base.
Page 2
WIRING INSTRUCTIONS Wire the relay coil from the AUX positive and negative connections of your OutBack product according to the diagram. The coil connections (A1 and A2) are not polarity sensitive and the LED will light in either polarity as long as proper voltage is present. (Required voltage is nominally 12 VDC, with a minimum of 9 volts.) If you are unsure, run the AUX positive wire to the A2 terminal and the AUX negative wire to the A1 terminal, twisting the wires together for a...
Page 3
TWO WIRE START GENERATOR HOOK UP GENERATOR 12V RELAY There are two screw terminals for each relay contact. Each can handle up to 8 amps. They are tied together internally. COM 11 and COM 21 are the common relay connections. Either can be used for loads under 8 amps.
Page 4
Corporate Office European Sales Office 19009 62nd Avenue NE C/ Castelló, 17 Arlington, WA USA 08830 - Sant Boi de Llobregat (+1) 360-435-6030 BARCELONA, España Phone: +34.93.654.9568 www.outbackpower.com 900-0018-01-00 REV A...