Using Windows 2000 With A Usb Or Parallel Cable - Dell 1710 User Manual

6.
7. Select your printer from the drop-down box.
8. Select Typical Installation (recommended), and then click Install.
When all of the files are installed on your computer, the Congratulations screen appears.
9. Click Print a Test Page to verify printer setup.
10. Click Finish to exit when the test page prints successfully.

Using Windows 2000 With a USB or Parallel Cable

When you attached the cable and turned on the printer, the Found New Hardware Wizard appeared on
your computer screen.
1. Insert the Drivers and Utilities CD, and then click Next.
2. Select Search for a suitable driver, and then click Next.
3. Select Specify a location only, and then click Next.
4. Browse to the location of the printer driver on the Drivers and Utilities CD.
D:\Drivers\Print\Win_2kXP\
Replace D:\ with the letter of your CD-ROM drive (for example, type D:\ where D is the drive letter of
your CD).
5. Click Open, and then click OK.
6. Click Next to install the driver that is displayed.
D:\Drivers\Print\Win_2kXP\dkaay2da.inf
7. Click Finish when the software is installed.
8. The Drivers and Utilities CD should launch the installation software automatically.
If the CD does not automatically launch, click Start Run, type D:\setup.exe (where D is the drive
letter of your CD), and then click OK.
9. When the Drivers and Utilities CD screen appears, click Personal Installation - Install the printer
for use on this computer only to install the additional software for your printer.
10. Select your printer from the drop-down box.
11. Select Typical Installation (recommended), and then click Install.
12.