Assembly; Assembling The Handlebar And Throttle; Assembling And Dismantling The Two-Piece Shaft - Husqvarna 135R Operator's Manual

Assembling the handlebar and
throttle
• Remove the screw at the rear of the throttle handle.
• Slide the throttle handle onto the right side of the
handlebar, (see diagram).
• Align the screw hole in the throttle handle with the hole
in the handlebar.
• Refit the screw in the hole in the rear of the throttle
handle.
• Screw the screw through the handle and handlebar.
Tighten it.
• Fit the mounting components as shown.
• Put on the harness and hang the machine from the
support hook. Now make a final adjustment so that
the machine is in a comfortable working position when
it hangs from the harness.
• Tighten the knob.
14 – English

ASSEMBLY

Assembling and dismantling the
two-piece shaft
Assembly
• Loosen the coupling by turning the knob counter-
clockwise.
• Align the tab of the attachment (A) with the arrow on
the coupling (B).
B
Push the attachment into the coupling until the
attachment snaps into place.
Before using the unit, tighten the knob securely.
Dismantling
Loosen the coupling by turning the knob (at least 3 times).
A