Using the touch controls
way to use the touch
pads on the cooktop
is with your finger
placed in the center of
the touch pad. If the
finger is not placed on
the center of a pad,
the cooktop may not
respond to the selection made.
Lightly contact the pad with the flat part of your entire
fingertip. Do not just use the narrow end of your
Cooktop main power pad
The Cooktop POWER
key pad enables the
To power the cooktop,
touch and hold the
POWER key pad for
1/2 second. A beep will
sound and the Power
LED will glow (See Fig. 3). The cooktop will be in a
ready mode for 10 seconds. If no other key pads are
touched the Cooktop Main POWER will turn OFF
To turn the Main Power OFF touch Main POWER key.
A beep will sound and the Power Indicator Light will
turn OFF (See Fig. 2).
Keep warm pad
Use the WARM key
pad to activate the
Keep warm setting
for any of the cooking
zones. First, activate
the zone by pressing
OFF key pad,
then touch the WARM key pad located in the Main
cooktop controls area. LH (low heat) should appear
in the corresponding cooking zone display (Fig. 5).
Main Cooktop Controls
Controls lock pad
The Induction Cooktop
may be locked in order
to prevent the cooktop
from accidentally being
To turn ON the Controls
Lock feature, make sure
the unit is powered OFF
(See above, Figure 1) and that the timer is not active.
Touch and hold the LOCK key pad for 3 seconds. A
beep will sound and the Lock indicator light will glow
(Fig. 7). Once locked, no other displays will glow and
no Cooking Zones or timer will activate.
To turn the Controls Lock OFF, touch and hold the
LOCK key pad for 3 seconds. A beep will sound,
the Lock indicator light will turn OFF (Fig. 6) and the
cooktop may be used normally. Remember to power
ON the cooktop if it is needed right away.
Minute timer pad
The Minute Timer feature may be useful in the kitchen
if a recipe calls for keeping track of time. This feature
will keep track of time from 1 to 99 minutes. The timer
display will begin to count down minutes once set.
To Set the Minute Timer
feature, touch the
listed over the word "timer".
Touching and releasing the
key pads will
increase or decrease the
Minute Timer setting by 1
minute with each key press (up to 99 minutes). You
may also hold the
your designated time.
Once the Timer LED displays the desired amount of
time, release the
8). The Minute Timer will begin the countdown with
remaining minutes. Once the Minute Timer reaches 1
minute, the timer will start counting down by seconds
until 00 is reached. Once the Minute Timer reaches
00 a long beep will sound indicating that the time is
up and the Timer display will flash 00.
To cancel or turn OFF the Minute Timer, Touch the
key pads at the same time or touch and hold
key pad and scroll to 00. The set
time will disappear from the display indicating that
the Minute Timer is no longer active.
key to slew the time to
Arrow key pads (Fig.