Assembling And Adjustments; General; Handle; Cutting Height - Husqvarna WB53S e Operator's Manual

General

IMPORTANT! Prevent unintentional
!
starting by removing the ignition cable
from the spark plug.

Handle

Assembly
• Assemble the upper handle using the handle nut on
the guide plate. Don't forget the washer between the
plate and the handle nut. No tools are needed for the
assembly.
Settings
• If necessary, the handle can be turned slightly
sideways with the handle joint. The handle can be set
to different positions to achieve the best driving
position, e.g. when mowing next to hedges or house
walls.
• The height of the lever can be adjusted in height. By
lifting the stay and sliding the handle forward or
backward, the height can be set at two positions.

ASSEMBLING AND ADJUSTMENTS

• When storing the machine, the handle can be set in
the storage position. Lift the stay and slide the handle
forward. Do not use this mode when mowing or driving
the lawn mower.

Cutting height

CAUTION! Do not set the cutting height too low as there
is a risk that the cutters might hit ground with unevenness.
The cutting height adjustment is spring assisted. The
cutting height can be adjusted in five different steps.
• To lower the cutting height move the lever to the left
and then forward.
• To raise the cutting height move the lever to the left
and then backward.

Filling with oil

• The oil tank is empty at delivery. Fill with oil up to the
"FULL" mark on the dipstick See also instructions
under the Maintenance heading. The engine oil
should be changed the first time after 5 hours running
time.
–
English 7