Fitting the loop handle
•
Position the loophandle on the shaft. Note that the handle
must be mounted below the arrow on the shaft.
•
Fit the screw, securing plate and wing nut as shown in the
diagram.
•
Tighten the wing nut.
Fitting the trimmer head
WARNING! When fitting the cutting
!
attachment it is extremely important that the
raised section on the drive disc/support
flange engages correctly in the centre hole
of the cutting attachment. If the cutting
attachment is fitted incorrectly it can result
in serious and/or fatal personal injury.
WARNING! Never use a cutting attachment
!
without an approved guard. See the chapter
on Technical data. If an incorrect or faulty
guard is fitted this can cause serious
personal injury.
10 –
English
ASSEMBLY
Fitting the trimmer guard and
trimmer head
•
Fit the correct trimmer guard (A) for use with the trimmer
head. Hook the trimmer guard/combination guard onto
the fitting on the shaft and secure with the bolt (L).
•
Fit the drive disc (B) on the output shaft.
•
Turn the output shaft until one of the holes in the drive disc
aligns with the corresponding hole in the gear housing.
•
Insert the locking pin (C) in the hole to lock the shaft.
•
Screw on the trimmer head/plastic blades (H) in the
opposite direction to the direction of rotation.
H
•
To dismantle, follow the instructions in the reverse order.
H
1157404-49 Rev. 1 2015-01-22