Horizontal Adjustment; Vertical Adjustment - Husqvarna CT151 Instruction Manual

2
1. Front bagger tube
2. Vinyl binding
1
3. Spreader bars
4. Retainer spring
5. Vinyl binding
8
6. Dump handle tube
7. Clevis pin 10 x 44mm
8. Retainer spring
9. Cap
1. Top Surfaces Even
2. Horizontal Adjustment Brack et
3. Vertical Adjustment Brack et
4. Bagger Latch
3
4
2
4
5
4
6
7
9
6MM (1/4") - 9MM (3/8")
1
2
02967
To Assemble Bagger
• Unfold bag by pivoting front bagger tube all the way forward
and pressing the bottom vinyl binding onto the tube.
• Inside the bag, install spreader bars and retainer springs
onto pins on both sides of bag as shown.
• Press the vinyl bindings onto the sides of front bagger
tube.
• Slide the bagger dump handle through the hole in the
bagger top, install the clevis pin 10 x 44mm and secure
with retainer spring.
• Push cap over end of bagger dump handle.
NOTE: For future use, the clevis pin may be removed in order
to use the handle to clear the chute in the event it has become
3
clogged.
Bagger adjustment
For proper bag function and appearance, it may be nec es -
sary to adjust the bagger assembly. There should be 6mm
(1/4")-9mm (3/8") gap between the bagger top and fender and
the bagger top surface should be even with the top surface
of the fender. To adjust bagger position:

Horizontal adjustment

• Slightly loosen the nuts securing the bagger RH and LH
hor i zon tal adjustment brackets. Loosen only enough so
the brackets keep their position, but allow them to be
moved.
5
• Move the brackets the amount forward or back ward you
wish the bag assembly to move. Retighten the nuts se-
curely.

Vertical adjustment

• Slightly loosen the nuts securing the vertical adjustment
brackets. Loosen only enough so the brackets keep their
position, but allow them to be moved.
• Move the brackets the amount up or down you wish the
bag assembly to move. Retighten the nuts securely.
• Reinstall the bagger as sem bly and check the bagger to
fender fit. If necessary, repeat the procedure until proper
fit is attained.
• After proper fit is attained, remove bagger from tractor
and install bagger latch (4) to tractor back plate as shown.
Tighten securely.
• Install and carefully lower bagger to actuate latch.
• Measure distance between bagger and latch as shown.
If distance is not 10mm - 16mm carefully remove bagger
and repeat vertical adjustment as needed.
10MM (7/16") - 16MM (5/8")
To convert to bagging, mulching or discharge
See "Sec tion 5" of this manual.
24
4