Assembly; Fitting The Handlebar; Assembling And Dismantling The Two-Piece Shaft - Husqvarna 525RX Operator's Manual

Fitting the handlebar

• Remove the screw at the rear of the throttle handle.
• Slide the throttle handle onto the right side of the
handlebar, (see diagram).
• Align the screw hole in the throttle handle with the hole
in the handlebar.
• Refit the screw in the hole in the rear of the throttle
handle.
• Screw the screw through the handle and handlebar.
Tighten it.
• Unscrew the knob from the handlebar mounting.
• Position the handlebar as shown. Fit the mounting
components and tighten the knob lightly.
12 – English

ASSEMBLY

• Put on the harness and hang the machine from the
support hook. Now make a final adjustment so that
the machine is in a comfortable working position when
it hangs from the harness. Tighten the knob.
Assembling and dismantling the
two-piece shaft (525RK)
Assembly
• Loosen the coupling by turning the knob.
• Align the tab of the attachment (A) with the arrow on
the coupling (B).
B
• Push the attachment into the coupling until the
attachment snaps into place.
• Before using the unit, tighten the knob securely.
A