Step 8. Assign The Ip Address; Finding The Dhcp Ip Address; Manually Assigning An Ip Address - HP 9200c Digital Sender Getting Started Manual

Step 8. Assign the IP address

In order to function properly, the device must be assigned a valid IP address on your
network. If your network uses dynamic host configuration protocol (DHCP), this IP address
can be assigned automatically. DHCP is the default setting in the digital sender. If you are
not using DHCP, you will need to manually assign an IP address.

Finding the DHCP IP address

Use one of the methods below to find the IP address that DHCP has automatically assigned.
●
●

Manually assigning an IP address

If you need to assign an IP address to the device, follow these instructions.
1. Press the
2. Touch CONFIGURE DEVICE.
3. Scroll down and touch I/O.
4. Scroll down and touch EMBEDDED JETDIRECT MENU.
5. Touch TCP/IP.
6. Touch CONFIG METHOD.
7. Touch MANUAL.
8. Touch MANUAL SETTINGS.
9. Touch IP ADDRESS and use the control-panel keypad to type in the unique IP address
16 Chapter 2 Setup
Look at the upper-left corner of the digital-sender control-panel display. Next to the word
Ready the IP address should appear.
If the IP address does not appear on the control-panel display, press the
the control panel. Touch the INFORMATION menu, and then touch CONFIGURATION.
The digital-sender configuration information appears on the touchscreen. Touch the OK
button to see the Jetdirect data. Scroll through the information until you find the IP
address.
M button on the control panel.
ENU
for the device.
M button on
ENU
ENWW