Replacing The Headlight Bulb - Yamaha VERSITY 300 VP300 Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
1 2 3 4 5 6
ZAUM0460
1. Backup fuse
2. Headlight fuse
3. Radiator fan fuse
4. Signaling system fuse
5. Ignition fuse
6. Auxiliary DC jack fuse
7. Spare fuse
6
8. Fuse tongs
The fuse block, which contains the fus-
es for the individual circuits, is located
in the storage compartment A. (See
page 3-12.)
If a fuse is blown, replace it as follows.
1. Turn the key to "
the electrical circuit in question.
2. Remove the blown fuse, and then
install a new fuse of the specified
amperage.
Specified fuses:
Main fuse:
8
30.0 A
Backup fuse:
3.0 A
Headlight fuse:
15.0 A
7 7
Radiator fan fuse:
15.0 A
Signaling system fuse:
15.0 A
Ignition fuse:
7.5 A
Auxiliary DC jack fuse:
3.0 A
CAUTION:
Do not use a fuse of a higher amper-
age rating than recommended to
avoid causing extensive damage to
the electrical system and possibly a
fire.
3. Turn the key to "
" and turn off
the electrical circuit in question to
check if the device operates.
4. If the fuse immediately blows
again, have a Yamaha dealer
check the electrical system.

Replacing the headlight bulb

This model is equipped with a quartz
bulb headlight. If the headlight bulb
burns out, replace it as follows.
1. Remove cowling A together with
2. Disconnect the headlight coupler,
ECA10640
ZAUM0461
1. Bulb cover
2. Headlight coupler
3. Remove the headlight bulb holder
" and turn on
6-27
the headlight unit. (See page 6-6.)
and then remove the bulb cover.
by pushing it inward and turning it
counterclockwise, and then re-
move the defective bulb.
EAU23841
1
2