Front Brake Lever - Yamaha VERSITY 300 VP300 Owner's Manual

position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch " "
Press this switch to sound the horn.
Engine stop switch " /
Set this switch to " " before starting
the engine. Set this switch to "
stop the engine in case of an emergen-
cy, such as when the vehicle overturns
or when the throttle cable is stuck.
Start switch " "
With the sidestand up, push this switch
while applying the front or rear brake to
crank the engine with the starter.
CAUTION:
See page 5-1 for starting instruc-
tions prior to starting the engine.
INSTRUMENT AND CONTROL FUNCTIONS
Hazard switch " ", "
With the key in the "
this switch to "
lighting (simultaneous flashing of all
EAU12500
turn signal lights). To turn off the hazard
lighting, set this switch to " " and, then
turn the key to "
EAU12660
" NOTE:
Even if the key is turned from "
" to
" " with the hazard lighting on, the
hazard lighting will continue to flash re-
gardless of the hazard switch position.
To cancel the hazard lighting, the key
must be turned to "
EAU12720 switch must be set to the " " position.
The hazard lighting is used in case of
an emergency or to warn other drivers
when your scooter is stopped where it
ECA10050 might be a traffic hazard.
CAUTION:
Do not use the hazard light for an ex-
tended length of time, otherwise the
battery may discharge.
EAUM1990
"

Front brake lever

" position, set
" to turn on the hazard
".
" to
ZAUM0084
1. Front brake lever
The front brake lever is located on the
right handlebar grip. To apply the front
" and the hazard
brake, pull this lever toward the handle-
bar grip.
ECA10060
3-8
EAU12900
1
3