Yamaha YZF-R1 Owner's Manual page 24

INSTRUMENT AND CONTROL FUNCTIONS
2. Push the "SELECT" button to stop
the stopwatch.
3. Push the "SELECT" button again
to reset the stopwatch.
Split-time measurement
1. Push the "RESET" button to start
the stopwatch.
3
2. Push the "RESET" button to mea-
sure split-times. (The colon ":" will
start flashing.)
3. Push the "RESET" button to dis-
play the final split-time or push the
"SELECT" button to stop the stop-
watch and display total elapsed
time.
4. Push the "SELECT" button to reset
the stopwatch.
Coolant temperature display
The coolant temperature display indi-
cates the temperature of the coolant.
Push the "RESET" button to switch the
coolant temperature display to the air
intake temperature display.
NOTE:
When the coolant temperature display
is selected, "C" is displayed for one
second, and then the coolant tempera-
ture is displayed.
CAUTION:
Do not operate the engine if it is
overheated.
Air intake temperature display
The air intake temperature display indi-
cates the temperature of the air drawn
into the air filter case. Push the "RE-
SET" button to switch the coolant tem-
perature display to the air intake
temperature display.
NOTE:
G
Even if the air intake temperature
is set to be displayed, the coolant
temperature warning light comes
on when the engine overheats.
G When the key is turned to "ON",
the coolant temperature is auto-
matically displayed, even if the air
intake temperature was displayed
prior to turning the key to "OFF".
3-10
G
When the air intake temperature
display is selected, "A" is displayed
before the temperature.
Self-diagnosis devices
This model is equipped with a self-diag-
ECA10020
nosis device for various electrical cir-
cuits.
If any of those circuits are defective, the
engine trouble warning light will come
on, and then the right display will indi-
cate a two-digit error code (e.g., 11, 12,
13).
This model is also equipped with a self-
diagnosis device for the immobilizer
system.
If any of the immobilizer system circuits
are defective, the immobilizer system
indicator light will flash, and then the
right display will indicate a two-digit er-
ror code (e.g., 51, 52, 53).
NOTE:
If the right display indicates error code
52, this could be caused by transpon-
der interference. If this error code ap-
pears, try the following.