Safety Warnings And Instructions - Black & Decker LDX116 Instruction Manual

b.Check t oseeif receptacle isconnected toa light s witch w hich turns power off
when youturnoutthelights.
c.Move charger andbattery p ack toa location w here t hesurrounding air
temperature isapproximately 65°F -75°F (18 °-24°C).
d.Ifcharging problems persist, take thetool, b attery p ack and charger toyour
local s ervice c enter.
4.Thebattery p ack should b erecharged when itfailstoproduce s ufficient power onjobs
which were easily done previously. DONOT CONTINUE touseunder these conditions.
Follow thecharging procedure. Youmay alsocharge a partially used pack whenever you
desire w ithnoadverse affect o nthebattery p ack.
5.Foreign m aterials ofa conductive nature s uch as,butnotlimited t o,steel w ool,
aluminum f oil, o ranybuildup o fmetallic particles should bekept a way f rom charger
cavities. Always u nplug t hecharger from thepower supply w hen there is nobattery p ack
inthecavity. Unplug charger before a ttempting toclean.
6.Donotfreeze o rimmerse charger inwater o ranyother l iquid.
z_WARNING:
Shock hazard. Do not allow any liquid to get inside charger. Never
attempt to open the battery pack for any reason. If the plastic housing of the battery pack
breaks or cracks, return to a service center for recycling.
SAFETY WARNINGS AND INSTRUCTIONS: DRILLS
1. Hold drill firmly with one hand on the grip and the other hand on the bottom of the
battery pack.
2. When attaching accessories in the drill chuck, hand tighten the keyless chuck firmly.
z_WARNING:
Drill may stall (if overloaded or improperly used) causing a twist. Always
expect the stall. Grip the drill firmly with both hands to control the twisting action and
prevent loss of control which could cause personal injury. If a stall does occur, release
the trigger immediately and determine the reason for the stall before re-starting.
INSTALLINGAND REMOVINGTHE BATTERYPACKFROM TItE TOOL
z_WARNING:
Make certain the lock-off button is engaged to prevent switch actuation
before removing or installing battery.
TO INSTALL BATTERY PACK: Insert battery
pack into tool until an audible click is heard
(figure B).
TO REMOVE BATTERY PACK: Depress the
battery release button as shown in figure C
and pull battery pack out of tool.
7