Removing The Device - Silvercrest SAR 28 A1 Operating Instructions Manual

Installation
CAUTION
Possible damage to the cable!
► To avoid damage, observe the position of the cables when sliding the
device into the bay.
♦ Carefully push the device into the installation bracket
place.
♦ After all the connections have been established, press the RESET
for about 6 seconds with a ballpoint pen or other sharp object.
♦ Attach the face plate as described under "Installing the face plate".

Removing the device

To remove the installed device, proceed as follows:
♦ Insert the right and left keys
device. (The tabs are now bent back).
♦ Pull the device out.
SAR 28 A1
into their respective slots on the sides of the
31
until it locks into
30
button
22
101
GB
MT