Yamaha 100A Owner's Manual page 58

V4
w
q
cC
Make sure the cowling lock connection
cable is operating correctly before rein-
stalling the top cowling.
8 When the release lever is operated,
both front and rear cowling hooks
should be released at the same time.
If not, adjust the cable adjuster for the
rear clamps.
8 Make sure the cable operates smoothly
and is free of corrosion.
8 Check that the cable is properly
secured in the holder.
8 When reinstalling the cowling, insure
that both the front and rear locks have
operated properly.
If the cowling has not been locked prop-
erly some parts may be damaged by the
top cowling shaking during operation.
If cowling does not unlock
If the cowling stays locked when the lever
is operated, the cable may be damaged or
misadjusted.
1) Pull the cowling release lever 1 to
unlock the front lock.
2) Pull the emergency cowling release
wire 2 coming out of the hole on the
e
side of the pilot hole in the bottom
cowling to release the port side rear
301026*
lock.
3) Lift the port side of the top cowling to
pull out the emergency cowling
release wire 3 from the port side of
the bottom cowling.
4) Pull the emergency cowling release
wire 3 to release the starboard side
rear lock.
cC
Be sure the problem with the cowling
lock is repaired before reinstalling the
cowling.
2-17
GB