Yamaha 100A Owner's Manual page 46

TACH TACH
x100 x100
r/min r/min
TACH TACH
x100 x100
r/min r/min
TACH TACH
x100 x100
r/min r/min
TACH TACH
x100 x100
r/min r/min
NOTE:
After the main switch is first turned on all
segments of the display come on as a
5 5
check. The tachometer and trim meter will
4 4
indicate the maximum reading and the
3 3
oil-level indicator and overheat warning
2 2
indicator will light. After a few seconds,
1 1
the meters will change to normal opera-
tion. Watch the meter when turning on
802012
the main switch to make sure all seg-
ments come on.
EMU00136
Tachometer
5 5
This meter shows the engine speed.
4 4
EMU01109*
3 3
Trim Meter
2 2
This meter shows the trim angle of your
1 1
outboard motor.
NOTE:
802042
8 Memorize the trim angles that work
best for your boat under different condi-
tions. Adjust the trim angle to the
desired setting by operating the power
5 5
trim and tilt switch.
8 If the trim angle of your motor exceeds
4 4
the trim operating range, the top seg-
3 3
ment on the trim meter display will start
2 2
to blink.
1 1
EMU00138
802015
Oil-Level Indicator
This indicator shows the engine oil level.
If the oil level falls below the lower limit,
the warning indicator will start to blink.
5 5
Refer to the sections "FILLING OIL" and
4 4
"OIL LEVEL WARNING" for details.
3 3
1 Oil-level indicator
2 2
1 1
cC
q
Do not operate the engine without oil.
802013
Serious engine damage will occ
2-11
GB