Table of Contents
Advertisement
Chapter 5. Initializing the G7052
System Status LEDs
Connecting to the Switch
Using the Serial Console Port
© Copyright Lenovo 2015
When you supply power to the G7052, the switch initializes automatically for basic
functions.
Statement 5
CAUTION:
The power control button on the device and the power switch on the power
supply do not turn off the electrical current supplied to the device. The device
also might have more than one power cord. To remove all electrical current
from the device, ensure that all power cords are disconnected from the power
source.
The following LEDs on the switch front panel indicate the overall system status:
•
Power: Steady green if the AC power cord is connected, or flashing green if the
internal power supply unit failed and the switch is powered by a Redundant
Power Supply through a DC to DC power cable.
•
Service ( ! ): Off if the system is OK, or flashing if service is required.
For additional LED indicators, see the appropriate section in
Components" starting on
Use the switch Command-Line Interface (CLI) to perform additional configuration
tasks. You can access the CLI using the serial console port or management port.
You can access the switch CLI through the serial console port on the front panel of
the switch. This port uses RS-232 serial communications. Use the console cable kit
to connect the serial console port to a terminal or a computer running a terminal
emulation program.
page
19.
Chapter 2, "Switch
69
Hide quick links:
Advertisement
Table of Contents
