Rj-45 Management Port; Reset Button - Lenovo RackSwitch G7052 Installation Manual

Hide thumbs Also See for RackSwitch G7052:
Table of Contents

Advertisement

RJ-45 Management Port

Reset Button

© Copyright Lenovo 2015
The RJ-45 management port on the front panel supports 10/100/1000BASE-T,
in-line switch management.
To attach an RJ-45 connector to the switch, push the RJ-45 cable connector into the
port connector until it clicks into place.
To disconnect the RJ-45 cable, squeeze the release tab and gently pull the cable
connector out of the switch connector.
RJ-45 Management LEDs
The RJ-45 management port LEDs are oriented as shown in the following figure.
Figure 5. RJ-45 management port LEDs
Link/Activity LED
Status LEDs for the RJ-45 management port are described in the following table.
Table 2. RJ-45 status LEDs behavior
LED
State
Link/Activity
Steady green
Flashing green
Off
Speed
Steady green
Off
The Reset button is recessed within a hole on the front panel. Use a straightened
paper clip or similar object to press the Reset button. The Reset button allows
technicians to reset the switch as follows:
Normal reset—Press and release Reset. The switch resets and reloads the
configuration files.
Factory reset—Press and hold Reset for more than five seconds. The switch
resets and reverts all configuration settings to the factory defaults.
Speed LED
Functional Meaning
Link up
Activity
No link
100/1000 Megabits per second (Mbps)
10 Mbps or no link
Chapter 2: Switch Components
21

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents