Yamaha FZ1-N Owner's Manual page 22

INSTRUMENT AND CONTROL FUNCTIONS
4. Push the "SELECT" button, and
the minute digits will start flashing.
5. Push the "RESET" button to set
the minutes.
6. Push the "SELECT" button and
then release it to start the clock.
Odometer and tripmeter modes
3
1. Odometer/tripmeter/fuel reserve tripmeter
Push the "SELECT" button to switch
the display between the odometer
mode "ODO" and the tripmeter modes
"TRIP A" and "TRIP B" in the following
order:
TRIP A → TRIP B → ODO → TRIP A
When the fuel amount in the fuel tank
decreases to 3.4 L (0.90 US gal) (0.75
Imp.gal), the left segment of the fuel
meter will start flashing, and the odom-
eter display will automatically change to
the fuel reserve tripmeter mode "F-
TRIP" and start counting the distance
traveled from that point. In that case,
push the "SELECT" button to switch the
display between the various tripmeter
and odometer modes in the following
order:
F-TRIP → TRIP A → TRIP B → ODO
→ F-TRIP
To reset a tripmeter, select it by push-
ing the "SELECT" button, and then
push the "RESET" button for at least
one second. If you do not reset the fuel
reserve tripmeter manually, it will reset
itself automatically and the display will
return to the prior mode after refueling
and traveling 5 km (3 mi).
3-8
Fuel meter
1. Fuel meter
The fuel meter indicates the amount of
fuel in the fuel tank. The display seg-
ments of the fuel meter disappear to-
wards "E" (Empty) as the fuel level
decreases. When only one segment is
left near "E", refuel as soon as possible.
NOTE:
This fuel meter is equipped with a self-
diagnosis system. If the electrical circuit
is defective, the following cycle will be
repeated until the malfunction is cor-
rected:"E" (Empty),"F" (Full) and sym-
bol " " will flash eight times, then go off
for approximately 3 seconds. If this oc-
curs, have a Yamaha dealer check the
electrical circuit.