Replacing A Turn Signal Light Bulb; Replacing The License Plate Light Bulb; Replacing An Auxiliary Light Bulb - Yamaha TENERE XT660Z Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
Replacing a turn signal light
bulb
1. Remove the turn signal light lens
by removing the screw.
6
1. Screw
2. Turn signal light lens
3. Turn signal light bulb
2. Remove the burnt-out bulb by
pushing it in and turning it coun-
terclockwise.
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screw. NOTICE: Do not over-
tighten the screw, otherwise
the lens may break.
EAU24204
Replacing the license plate
light bulb
1. Remove the socket (together
with the bulb) by pulling it out.
1. License plate light bulb socket
2. License plate light bulb
2. Remove the burnt-out bulb by
pulling it out.
3. Insert a new bulb into the socket.
4. Install the socket (together with
the bulb) by pushing it in.
[ECA11191]
EAUM2202
Replacing an auxiliary light
bulb
This model is equipped with two auxi-
liary lights. If an auxiliary light bulb
burns out, replace it as follows.
1. Remove panel G. (See page 6-8).
2. Remove the auxiliary light socket
1. Auxiliary light bulb socket
2. Auxiliary light bulb
3. Remove the burnt-out bulb by
4. Insert a new bulb into the socket.
6-34
(together with the bulb) by pulling
it out.
pulling it out.
EAU42652