Step 14 - Connect Power Supply; Step 15 - Pre-Test Checklist - GE GLDT696J-SS Installation Instructions Manual

Hide thumbs Also See for GLDT696J-SS:
Table of Contents

Advertisement

Available languages

Available languages

STEP 14 – CONNECT POWER SUPPLY
Skip this step if equipped with power cord.
A. Remove junction box cover "A".
B. Locate the three dishwasher wires, (white, black and
green) with stripped ends. Insert dishwasher wires
through the small hole in the junction box "B".
C. Secure house wiring to the bottom of the junction box
with a strain relief "C".
D. Use wire nuts to connect incoming ground to green,
white to white and black to black "D".
E. Replace junction box cover "E". Check to be sure that
wires are not pinched under the cover.
A
Remove
green dishwasher wires are threaded
junction box
cover
Ground
E
D
Replace
Use UL Listed
junction box
wire nuts
cover
WARNING:
If house wiring is not 2-wire with ground, a ground
must be provided by the installer. When house wiring
is aluminum, be sure to use UL Listed anti-oxidant
compound and aluminum to copper connectors.
Installation Instructions
B
Check that white, black and
through hole in back
White
Black
C
Insert power
cord wires through
strain relief
and tighten
STEP 15 – PRE-TEST CHECKLIST
Review this list after installing your dishwasher to
avoid charges for a service call that is not covered
by your Warranty.
Check to be sure Power is OFF.
Open door and remove all foam and paper packaging.
Locate the Owner's Manual in the literature package.
Read the Owner's Manual for operating instructions.
Check door opening and closing. If door does not
open and close freely or tends to fall, check spring
adjustments. See Step 1.
Check to be sure that wiring is secure under the
dishwasher, not pinched or in contact with door
springs or other components. See Step 9.
Check door alignment with tub. If door hits tub, level
dishwasher. See Step 10.
Pull lower rack out about half way. Check to be sure it
does not roll backward or forward on the door. If the
rack moves, adjust leveling legs. See Step 10.
Check door alignment with cabinet. If door hits
cabinet, reposition or relevel dishwasher. See Step 10.
Verify water supply and drain lines are not kinked or in
contact with other components. Contact with motor or
dishwasher frame could cause noise. See Step 8.
Turn on the sink hot water faucet and verify water
temperature. Incoming water temperature must
be between 120°F and 140°F. A minimum of 120°F
temperature is required for best wash performance.
See PREPARE HOT WATER LINE, page 5.
Add 2 quarts of water to the bottom of the dishwasher
to lubricate the pump seal.
Turn on water supply. Check for leaks. Tighten
connections if needed.
Remove protective film if present from the control
panel and door.
11

Advertisement

Table of Contents
loading

Table of Contents