Removing The Doors - Electrolux ei28bs55is1 Use And Care Manual

Removing the Doors

10
Getting through narrow
spaces
If your refrigerator will not fit through an
entrance area, you can remove the doors.
Check first by measuring the entrance.
To prepare for removing the doors:
1 Make sure the electrical power cord is
unplugged from the wall outlet.
2 Open the freezer drawer and remove the
toe grille (see "Installation" section).
3 Remove any food from the door shelves
and close the doors.
To remove the top hinge covers:
1 Remove the two screws from each cover
over the top door hinges.
2 Lift inside edge of hinge cover and tilt back.
Top Hinge
Cover
Hinge
Screws
Multi-wire
Cables
Leave
Hinge
With
Door
Rear
Cover
Screw
Ground
Top
Screw
Hinge
NOTE
DO NOT remove the ground screw from
hinge.
Front
Rear
Cover Screw
Cover
Screw
Ground
Screw
Front
Cover Screw
Top Hinge
Cover
Hinge
Screws
Two Wire
Cables
To remove the refrigerator doors:
1 Trace lightly around the door's top hinges
with a pencil. This makes reinstallation easier.
2 Disconnect the harness by grasping both
sides of the connector firmly, depress the
latch, and pull apart. Remove the two
screws from the top hinge. Lift the door
off of the bottom hinge and set it aside.
3 Detach the water tube from the
connector located behind the refrigerator
and pull the tube back out to the front
of the unit. The connector releases
when you press inward on the outer
sleeve while pushing the tube toward the
connector then while continuing to hold
in the sleeve, pull the tube away.
Top
Hinge
Water
Line
4 Unscrew the three lower hinge screws
and hinge if necessary.
Leave
Hinge
With
Door
Use care while pulling the water tube from
the unit to be sure you do not kink it.
NOTE