Table of Contents
Advertisement
•
Remove all accessories before running the pyrolysis function.
•
For optimum cleaning of the oven door, remove the worst soiling with a damp sponge before using the pyrolytic function.
The appliance is equipped with 2 pyrolysis functions:
1.
Energy-saving cycle (PYRO EXPRESS/ECO): which consumes approximately 25% less energy than the standard cycle.
Select it at regular intervals (after cooking meat on 2 or 3 consecutive occasions).
2.
Standard cycle (PYRO): which is suitable for cleaning a very dirty oven.
•
In any case, after a certain number of uses and depending on how dirty the oven is, a message on the oven display advises
you to run a self-cleaning cycle.
N.B.: during the pyrolysis function, the oven door will not open; it will remain locked until the temperature inside the
oven has returned to an acceptably safe level.
MAINTENANCE
WARNING
REMOVING THE DOOR
To remove the door:
1.
Open the door fully.
2.
Lift the catches and push them forwards as far as they will go (fig. 1).
3.
Close the door as far as it will go (A), lift it up (B) and turn it (C) until it is released (D) (fig. 2).
To refit the door:
1.
Insert the hinges in their seats.
2.
Open the door fully.
3.
Lower the two catches.
4.
Close the door.
Fig. 1
Fig. 2
MOVING THE TOP HEATING ELEMENT (SOME MODELS ONLY)
1.
Remove the side accessory holder grilles (Fig. 3).
2.
Pull the heating element out a little (Fig. 4) and lower it (Fig. 5).
3.
To reposition the heating element, lift it up, pulling it slightly towards you, making sure it comes to rest on the lateral
supports.
Fig. 3
Fig. 4
REPLACING THE OVEN LAMP
To replace the rear lamp (if present):
1.
Disconnect the oven from the power supply.
2.
Unscrew the lamp cover (Fig. 6), replace the lamp (see note for lamp type) and screw the lamp cover back on.
3.
Reconnect the oven to the power supply.
To replace the side lamp (if present):
1.
Disconnect the oven from the power supply.
2.
Remove the side accessory holder grilles, if present (Fig. 3).
3.
Use a screwdriver to prise off the lamp cover (Fig. 7).
4.
Replace the lamp (see note for lamp type) (Fig. 8).
5.
Reposition the lamp cover, pushing it on firmly until it snaps into place (Fig. 9).
6.
Refit the side accessory holder grilles.
7.
Reconnect the oven to the power supply.
-
Use protective gloves.
-
Ensure the oven is cold before carrying out the following operations.
-
Disconnect the appliance from the power supply.
Fig. 5
EN86
Advertisement
Table of Contents
