Operation - Makita UH4570 Instruction Manual

sole hook only attached may cause an accident
and injury.
Using the waist cord hook helps to minimizing a risk of
cutting off the extension cord unexpectedly caused by
the loose extension cord.
7
1. Hook
2. Tool
3. Tool's cord
4. Hook complete
5. Extension cord
6. Holder
7. Waist cord hook
009278
Press in or pull out the cord through the opening of the
holder.
Fig.6
CAUTION:
Do not force the opening of the holder. Failure to
•
do so may cause deflection and damage to it.
Arm cord hook (Accessory)
CAUTION:
Do not attach the holder of arm cord hook to other
•
than the extension cord. Do not attach it in a
position closer to the tool beyond the hook
complete hooks. Failure to do so may cause an
accident or personal injury.
Attach firmly one hook of the hook complete to the
•
tool's cord and the other hook of hook complete to
the extension cord. Working with the tool with a
sole hook only attached may cause an accident
and injury.
Using the arm cord hook helps to minimize a risk of
cutting off the extension cord unexpectedly caused by
the loose extension cord.
1
3
4
5
6
Fig.7
Attach firmly the arm cord hook placing around your arm
and pass the extension cord through the holder. The
length of the arm cord hook band is adjustable.
NOTE:
Do not pass the extension cord through the band.
•
Do not force the opening of the holder. Failure to
•
do so may cause deflection and damage to it.
2
Using the arm cord hook together with the waist
•
cord hook is more helpful.

OPERATION

CAUTION:
Be careful not to accidentally contact a metal
•
fence or other hard objects while trimming. The
blade will break and may cause serious injury.
Overreaching with a hedge trimmer, particularly
•
from a ladder, is extremely dangerous. Do not
work from anything wobbly or infirm.
Do not attempt to cut branches thicker than 10 mm
diameter with this trimmer. These should first be cut with
shears down to the hedge trimming level.
Fig.8
CAUTION:
Do not cut off dead trees or similar hard objects.
•
Failure to do so may damage the tool.
Hold the trimmer with both hands pull the switch trigger
A or B and move it in front of your body.
Fig.9
As a basic operation, tilt the blades towards the
trimming direction and move it calmly and slowly at the
speed rate of 3 - 4 seconds per meter.
Fig.10
Fig.11
To cut a hedge top evenly, it helps to tie a string at the
desired hedge height and to trim along it, using it as a
reference line.
Fig.12
Attaching the chip receiver (accessory) on the tool when
trimming the hedge straight can avoid cut off leaves'
being thrown away.
Fig.13
To cut a hedge side evenly, it helps to cut from the
bottom upwards.
Fig.14
Trim boxwood or rhododendron from the base toward
the top for a nice appearance and good job.
Fig.15
8