Download  Print this page

Vac & Steam Special Features; Caring For Your Vac & Steam - Electrolux Vac & Steam Owner's Manual

Hide thumbs

Advertisement

Table of Contents
87909rev2_VacSteam.qxp:English
Vac & Steam special features
Clean burst pedal
A special 'clean burst' feature provides a focused burst of
steam for spot cleaning difficult-to-remove soil.
To use the clean burst feature:
I
It is recommended to turn vacuum off; use steam feature
only for best performance.
I
Press clean burst pedal to 'spot clean' position for five to
10 seconds. Allow steam burst to spray onto dried spills or
spots (Fig. 1).
I
Move floor nozzle back and forth to clean soiled area (Fig. 2).
I
Return pedal to 'floor mop' position after using clean burst.
The steam feature can kill dust mites and some types of
bacteria when used properly. To disinfect a specific area, turn
steam on and position Vac & Steam over the area for a
minimum of eight seconds. This allows the floor under the
steamer to reach approximately 170
to disinfect floors in bathrooms, pet sleeping quarters, etc.
Caring for your Vac & Steam
I
Unplug and allow Vac & Steam to cool.
I
Slide dust cup latch left, to 'unlock' position (Fig. 3).
I
Remove dust cup. Twist top of dust cup to lift out screen.
Empty debris from dust cup (Fig. 4).
I
Remove sponge filter from top of screen. Wash sponge,
screen and dust cup in warm water. Allow to dry before
reassembling (Fig. 5).
I
Remove cleaning pad after use. Allow Vac & Steam to cool
completely, then step on pad lip and lift off Vac & Steam
(Fig. 6).
I
Wrap power cord and store Vac & Steam in upright
position.
I
Wash cleaning pads in warm water, by hand or machine.
Do not use fabric softener. Lay flat to dry.
10/15/13
3:08 PM
Page 7
N O T I C E
o
F. Use this procedure
Fig. 1
Fig. 3
Fig.5
Electrolux Customer Service Helpline 1-800-896-9756
Fig. 2
Fig. 4
Fig. 6
5

Advertisement

Table of Contents
loading