Wiring Example And How To Set The Remote Controller - Panasonic CS-20PM1HPK Installation Manual

9. WIRING EXAMPLE AND HOW TO SET THE REMOTE CONTROLLER

9-1 HOW TO CONNECT WIRINGS
• Remove the electric parts box cover and connect the wiring.
NOTES
• Remote controller wiring and crossover wiring should be run
at least 50 mm from the power cable. if too close, malfunction
could result from electronic noise (noise from outside).
• For remote control wiring, see "Remote Controller Installation
Instructions."
• For electric wiring, also see "Electric Wiring Schematic Dia-
gram" label.
• Be sure not to connect the power cable to the terminal block
(for remote controller and crossover wiring). Doing so could
damage the entire system.
• Remote controller cord, crossover wiring
Do not confuse the two when connecting to the terminal block
(for remote controller and crossover wiring).
• Fasten the wiring with accessory clamp (6).
• If mounting a remote controller on the unit, wire as shown in
the figure on the right.
• If wiring from the piping side, wire as shown in the figure on the right.
Pass through hole
of opposite frame
panel in same
manner.
Wiring between units (∗)
CAUTION
• When cramping wiring, use the included cramping material to do an appropriate cramp to prevent undue
pressure on the wiring connections. When carrying out the wiring, bundle the wires to prevent the switch
box lid from lifting, and attach the lid firmly. When attaching the switch box avoid getting wires caught always
use a wiring through-lid to prevent damage to the wires.
• Make sure to avoid external force to the field wiring(∗) such as by laying them in protection pipes or in the
wall.
English
Electric parts box
Remote controller
wire (∗)
Connecting wiring (∗)
Electric parts box
Wiring between
units (∗)
Connecting
wire (∗)
Clamp
(accessory)
Cut off excess after
fastening.
Pass through hole of
remote controller
fastening plate.
Fasten with accessory clamp (6).
Clamp fastener
10