Black & Decker LST 136 Instruction Manual page 12

• Align the tabs on the spool
cap with the slots (R1) in the
housing (figure R).
• Push the cap onto the
housing until it snaps securely
into place.
CAUTION:
To avoid tool
damage, if the cutting line
protrudes beyond the
trimming blade, cut it off so that it just reaches the blade.
REWINDING SPOOL FROM BULK LINE
(USE ONLY .065 IN. ROUND DIAMETER LINE) (FIGURES S, T & U)
Bulk line is also available for purchase from your local retailer.
NOTE: Hand wound spools from bulk line are likely to become
tangled more frequently than Black & Decker factory wound
spools. For best results, factory wound spools are
recommended.
To install bulk line, follow the steps below:
• Remove battery from tool.
• Remove the empty spool
from the tool as described
in "REPLACING THE
SPOOL".
• Remove any remaining
cutting line from the spool.
• Make a fold at the end of
the cutting line at about 3/4
inch (19mm)(S1). Feed the
cutting line into one of the
line anchoring slots (S2) as
shown in figure S.
R
R1
S
S2
• Insert the 3/4 inch (19mm)
end of the bulk line into the
hole (T1) in the spool
adjacent to the slot as
shown in figure T.
R2
• Wind the cutting line onto the spool in
the direction of the arrow on the spool.
Make sure to wind the line on neatly and
in layers. Do not crisscross (figure U).
• When the wound cutting line reaches
the recesses (T2), cut the line. (figure T).
• Fit the spool onto the tool as described
in "REPLACING THE SPOOL".
S1
THE RBRC™ SEAL
The RBRC™ (Rechargeable Battery Recycling
Corporation) Seal on the Li-Ion battery (or battery pack)
indicates that the costs to recycle the battery (or battery
pack) at the end of its useful life have already been paid
by Black & Decker.
RBRC™ in cooperation with Black & Decker and other battery users,
has established programs in the United States to facilitate the
collection of spent Li-Ion batteries. Help protect our environment and
conserve natural resources by returning the spent Li-Ion battery to an
12
T2
T
T1
U