Instrument Panel - Ford mustang 2005 Quick Reference Manual

1 HEADLAMP CONTROL AND FOGLAMPS
Turning the headlamp control clockwise to the first position turns on the parking
lamps, instrument panel lamps, license plate lamps and the tail lamps. Continuing to
turn the headlamp control to the second position turns on the headlamps in addition
to the previous lamps. To activate the high beams, pull the turn signal lever toward
you to the second detent. Pull the lever toward you again to deactivate them. Use the
same lever to activate the "Flash to Pass" feature. Pull the lever toward you to the first
detent to activate and release quickly to deactivate.
The fog lamps can be turned on when the headlamp control is in the parking lamp or
headlamp position and the high beams are not on. Pull the headlamp control toward
you to turn on the fog lamps. The fog lamp indicator light will illuminate. Remember,
the fog lamps will not operate when the high beams are activated.
2 PANEL DIMMER
Use to adjust the brightness of the instrument panel and all applcable switches in the
vehicle during headlamp and park lamp operation. Rotate the control fully upward,
past the detent, to turn on the interior lamps.
3 ANTI-LOCK BRAKE SYSTEM
The ABS warning lamp will momentarily illuminate when the ignition is turned on.
If the light stays on, flashes or doesn't illuminate, have your vehicle serviced. In an
emergency, apply continuous force to the brake pedal. Do not pump the brakes. Any
pulsation or mechanical noise you may feel or hear is normal.
4 SERVICE ENGINE SOON LAMP
The Service Engine Soon indicator lamp illuminates when the ignition is first turned to
the ON position. If the lamp stays on or blinks, the On Board Diagnostics System has
detected a malfunction. Drive moderately (avoid heavy acceleration or deceleration)
and have your vehicle serviced immediately.
5 GEARSHIFT/OVERDRIVE CONTROL
Use overdrive in the normal D (Drive) position for the best fuel economy. D (Drive) with
Overdrive can be deactivated by pressing the transmission control switch on the right
side of the gearshift. Use this position only when driving conditions cause excessive
shifting from O/D to other gears. Examples: city traffic, hilly terrain, heavy loads, etc., or
when engine braking is required.*
MUSTANG 2005

INSTRUMENT PANEL

(IF EQUIPPED)
(IF EQUIPPED)
(IF EQUIPPED)