Black & Decker KC460LN H1 Manual page 5

When assessing vibration exposure to determine
safety measures required by 2002/44/EC to protect
persons regularly using power tools in employment,
an estimation of vibration exposure should consider,
the actual conditions of use and the way the tool is
used, including taking account of all parts of the
operating cycle such as the times when the tool is
switched off and when it is running idle in addition
to the trigger time.
Labels on tool
The following pictograms are shown on the tool:
Warning! To reduce the risk of injury, the
user must read the instruction manual.
Additional safety instructions for
batteries and chargers
Batteries
• Never attempt to open for any reason.
• Do not expose the battery to water.
• Do not expose the battery to heat.
• Do not store in locations where the temperature
may exceed 40 °C.
• Charge only at ambient temperatures between
10°C and 40 °C.
• Charge only using the charger provided with the
appliance/tool.
• When disposing of batteries, follow the instruc-
tions given in the section "Protecting the environ-
ment".
• Do not damage/deform the battery pack either
by puncture or impact, as this may create a risk
of injury and fi re.
• Do not charge damaged batteries.
• Under extreme conditions, battery leakage may
occur. When you notice liquid on the batteries
carefully wipe the liquid off using a cloth. Avoid
skin contact.
• In case of skin or eye contact, follow the instruc-
tions below.
Warning! The battery fl uid may cause personal
injury or damage to property. In case of skin con-
tact, immediately rinse with water. If redness, pain
or irritation occurs seek medical attention. In case
of eye contact, rinse immediately with clean water
and seek medical attention.
Chargers
Your charger has been designed for a specific
voltage. Always check that the mains voltage cor-
responds to the voltage on the rating plate.
Warning! Never attempt to replace the charger unit
with a regular mains plug.
• Use your Black & Decker charger only to charge
the battery in the tool with which it was supplied.
Other batteries could burst, causing personal
injury and damage.
• Never attempt to charge non-rechargeable bat-
teries.
• If the supply cord is damaged, it must be re-
placed by the manufacturer or an authorised
Black & Decker Service Centre in order to avoid
a hazard.
• Have defective cords replaced immediately.
• Do not expose the charger to water.
• Do not open the charger.
• Do not probe the charger.
• The appliance/tool/battery must be placed in
a well ventilated area when charging.
The charger is intended for indoor use
only.
Read the instruction manual before use.
Fail safe isolating transformer. The mains
supply is electrically separated from the
transformer output.
The charger automatically shuts off if the
ambient temperature becomes too high. As
a consequence the charger will be inoper-
able. The unit must be disconnected from
the mains supply and taken to an authorised
service centre for repair.
Electrical safety
Your charger is double insulated; therefore
no earth wire is required. Always check that
the mains voltage corresponds to the volt-
age on the rating plate.
• If the supply cord is damaged, it must be re-
placed by the manufacturer or an authorised
Black & Decker Service Centre in order to avoid
a hazard.
• Warning! Never attempt to replace the charger
unit with a regular mains plug.
Features
1. On/off switch
2. Forward/reverse slider
3. Bit holder
4. LED light
ENGLISH
5