Get Started; Power Supply; Set Time - Philips AJ4800 User Manual

3 Get started

Always follow the instructions in this chapter in
sequence.

Power supply

Either AC power or battery can be used as
power supply of this product.
Option A: AC power
Caution
•
Risk of product damage! Make sure that the power
voltage corresponds to the voltage printed on the back
or underside of the clock radio.
•
Risk of electric shock! When you unplug the AC plug,
always pull the plug from the socket. Never pull the cord.
1
Connect one end of the AC adaptor to
the DC 7.5V socket on the back of the
clock radio.
2
Connect the other end of the AC adaptor
to the wall outlet.
Option B: Battery power
Caution
•
Risk of explosion! Keep batteries away from heat,
sunshine or fire. Never discard batteries in fire.
•
Danger of explosion if batteries are incorrectly replaced.
Replace only with the same or equivalent type.
•
The batteries contain chemical substances, so they
should be disposed of properly.
1
Open the battery compartment on the
bottom of the clock radio.
2
Insert 4 x 1.5V R6/UM3/AA batteries (not
supplied) with correct polarity (+/-) as
indicated.
3
Close the battery compartment.
» The clock radio is ready to operate.
Tip
•
When the battery level is low, the low battery indicator
is displayed.

Set time

1
Press SET TIME to activate time setting
mode.
2
Press + PRESET/ HR - or + TUNING/
MIN - to set 12/24 hour format.
3
Press SET TIME to confirm.
» The hour and minute digits blink.
4
Press + PRESET/ HR - to set hour.
5
Press + TUNING/ MIN - to set minute.
6
Press SET TIME to confirm.
» The set time is displayed.
EN 5