Table of Contents
Advertisement
Cleaning/Maintenance
14.
Please unplug the power plug from the socket before cleaning and maintenance.
After finishing washing, please turn off the water tap and remove the water inlet pipe.
Unplug the power plug and put back the drain pipe.
If the washer-dryer is not to be used for a long time, please keep the door slightly open and dry the window pad to
avoid unpleasant smell.
Do not use organic solvent or corrosive liquid to wipe the washer-dryer's exterior and rubber parts.
Frequently clean both the water inlet pipe joint and water inlet valve filter screen to prevent them from being clogged
by dirt.
To clean the drain filter (once every 30 days)
(1) After draining the water in the washer-dryer, press the filter cover with a hand to open it as shown in Fig. 1.
(2) Press the push switch to the end to prevent the hand from being wounded when turning the filter knob, then
anticlockwise screw out the drain filter with a hand.
Note: A little water may flow out when screwing out the filter knob (if Err2 alarm appears, relatively much water
may flow out when screwing out the filter knob). Therefore, prepare a container (e.g. basin) before screwing out the
filter knob and make the water flow in the container but not onto the ground or floor.
(3) Remove the thrums and impurities on the filter and rinse the filter with clean water.
(4) Insert the filter along the groove and tighten it by turning clockwise; otherwise water leakage may occur. Be careful
not to distort the filter.
Note: The drain filter must be tightened to avoid water leakage.
(5) Press the push switch again with a hand to make it bounce out, then close the filter cover.
Push
switc
Drain
filter knob
Drain
filter
cover
F
g i
1 .
F
g i
2 .
To clean the distributor box
(1) Fully pull out the distributor box.
(2) Slightly lift up and pull out the distributor box.
(3) Rinse the distributor box and siphon cap with clean water.
(
) 4
B
c u
l k
t e
e h
i s
h p
n o
a c
, p
h t
n e
n i
e s
, t r
u p
h s
n i
a
d n
l c
box.
Note: Please buckle the siphon cap in the correct position of distributor box; otherwise the detergent and softener in the
Loosen
Groove
F
g i
3 .
s o
t e
e h
i d
r t s
b i
t u
r o
distributor box cannot be siphoned into the washer-dryer's drum.
To clean the drying filter box
Note: Please clean the drying filter box after using the drying function every time.
(1) Pull out the drying filter box as shown in Fig. 1.
(2) Gently open the drying filter box cover as shown in Fig. 2.
(3) Remove the flocking in the drying filter box with a soft bristle brush as shown in Fig. 3.
(4) Close the drying filter box and install it in place.
Fig. 1
Note: The flocking must not be piled up around the washer-dryer to avoid its entry into the washer-dryer and poor drying
effect.
To clean the water inlet filter screen
Warm tips: To improve the washing effect, do not
throw away the water inlet filter screen. In case of
unsmooth water feed, please clean the water inlet
filter screen in time as follows:
(
) 1
c S
e r
w
f o
t f
e h
w
a
e t
r
n i
t e l
i p
e p
a
s s
o h
w
n
n i
F
. g i
, 1
then take out the filter screen with a pair of nipper
pliers as shown in Fig. 2.
(2) Wash the filter screen with a soft bristle brush.
(3) Install the filter screen in place and connect the
water inlet pipe.
Fig. 2
Fig. 3
n a
d
Fig. 1
Fig. 2
Advertisement
Table of Contents
