Disassembly For Repair - Kenwood DV-4050-B Service Manual

1. How to Remove Tray
1. Remove the front panel and flexible cable.
Disassemble the X25 and power supply pcb with sub
chassis if it is a difficult.
2. Push and hold the lever( )to clockwise and pull barely
out the tray to frontwards( ) where the hook of tray( )
meets with guide( ).
3. Push hooks( ), both sides, inwards and release them
from guides( ).
4. Pull hooks of tray( ) outwards and remove the tray
upwards( ).
2. How to Assemble Tray
1. Adjust the position of drive gear as figure( ).
Check traverse unit is at the lowest position.
2. Load the tray on the loading mechanism.
Check the position where the loading gear(A) is free( )
3. Meet the hooks with guides and push hooks to load the
tray( ).
4. Set the right side hook to loading mechanism( ).
5. Set the left side hook to loading mechanism with pulling it
outwards( ).
6. Push the tray backwards( ).
DV-4050-B/DVF-R6030-B

DISASSEMBLY FOR REPAIR

1
2
4
PROTRUSION OF TRAY
LOADING
GEAR (A)
2
(Free)
5
REAR
HOOK
6
3
5
HOOK ( x2)
6
3
5
x2
HOOK
Guide
1
ARM
DRIVE
GEAR
4
HOOK
GUIDE
3