Technical Data; Installation - AEG A72200GSW0 User Manual

34

Technical data

Problem
The lamp does not work.
Door interferes with venti-
lation grill.
Misaligned door.
As much as the advice does not lead to result, call the nearest brand-mark service.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.
TECHNICAL DATA
Dimension
Rising Time
Voltage
Frequency
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.

INSTALLATION

WARNING!
Read the "Safety Information" carefully for your safety and correct operation of the appli-
ance before installing the appliance.
Positioning
Install this appliance at a location where the ambient temperature corresponds to the cli-
mate class indicated on the rating plate of the appliance:
Possible cause
The appliance has no power.
There is no voltage in the mains
socket.
The lamp is defective.
The door has been open to long.
The appliance is not levelled.
The appliance is not levelled.
Height
Width
Depth
Solution
Connect another electrical appli-
ance to the mains socket. Check
fuse. Contact a qualified electri-
cian.
Refer to "Replacing the lamp".
Close the door.
Refer to "Levelling".
Refer to "Levelling".
1540 mm
595 mm
658 mm
20 h
230-240 V
50 Hz