Self Diagnosis Function - Hitachi 28LD5200E Service Manual

6. Self-Diagnosis Function
Signal circuit check mode: It indicates the check result on some points of the signal circuit and the history of them with On-Screen Display (OSD).
Signal circuit self-diagnosis function
This function is for the failure of the signal circuit, for example the phenomenon as below:
"Sometimes power turns off abnormally." "Sometimes picture disappears abnormally."
To enter to this Self-Diagnosis mode, follow the next steps:
Preparation:
1) The Power Cord should be connected to AC line and the Main Power switch should be turned on.
2) Turn the power off by the SUB-POWER(
Procedure:
1) Press the SUB-POWER(
2) The monitor will be turned on, and it will display On-Screen Display of the Self-check result and the failure history as below.
3) Any operation would cancel the Self -Diagnosis mode.
4) The following table shows the OSD symbols and contents of failure PWB in which failure most probably would be allocated according to the number of blinks.
Check item
Code stored up in
failure history
(
C10 *
(
H11 *
H15
H16
H31
H32
H33
(
H71 *
(
H72 *
F63
)
* This code is no meaning for the models except 32/42PD5000TA because those are without tuner circuit.
If you clear history of failure, make FACTORY RESET: enter the factory setting mode; press the SUB-POWER( )
button, INPUT SELECT(
more than 5 seconds after the power turned on.
Downloaded From TV-Manual.com Manuals
28LD5200E (PW1L)
) button of the monitor or the remote control.
) button and button on the bottom of the monitor at the same time, and keep it for more than 5 seconds after the power turned on.
Check result
Self Check
H11: OK
H16: OK
H32: OK
F63 F63 - - -
Latest error code
Self checking Problem
item
No sync. (Snow noise)
Tuner problem
Composite video SW IC
problem
Component video SW IC
problem
Color demodulator IC
problem
Sync. separator IC
problem
3D Y/C separator IC
problem
T/Text IC problem
Sound MPX IC problem
2
I C-bus latch problem
) button and button on the bottom of the monitor at the same time. And keep it for
[OSD]
H15: OK
Self check result area
H31: OK
H33: OK
Failure history area
- - - - - -
Phenomenon
OSD of " ! Check Antenna "
appears.
Cannot receive the main
signal from antenna
Cannot receive picture and
audio
Cannot change input mode
No component picture
Cannot change input mode
Abnormal color
Dark picture
Unsynchronized picture
Abnormal color
Dark picture / No picture
No T/Text
No picture
No sound from antenna
Cannot change MPX
sound
Cannot store setting data
(Ex. Channel, Volume etc.)
22
Cause
No connection of ANT cable
Preset tuning is not yet
Communication error of U101
Communication error of I201
Communication error of I202
Communication error of I501
Communication error of I601
Communication error of I302
Communication error of IT01
Communication error of IN01
SCL3/SDA3 latched up