D-Link DAP-2695 User Manual page 26

Section 3 - Configuration
User Limit:
Set the maximum amount of users that are allowed access (zero to 64 users) to the device using the specified wireless
band. The default setting is 20.
11n Preferred: Use the drop-down menu to Enable the 11n Preferred function. The wireless clients with 802.11n protocol will have
higher priority to connect to the device.
Network Utilization:
Set the maximum utilization of this access point for service. The DAP-2695 will not allow any new clients to associate
with the AP if the utilization exceeds the value the user specifies. Select a utilization percentage between 100%, 80%,
60%, 40%, 20%, or 0%. When this network utilization threshold is reached, the device will pause one minute to allow net-
work congestion to dissipate.
Aging out: Use the drop-down menu to select the criteria of disconnecting the wireless clients. Available options are RSSI and Data
Rate.
RSSI Threshold: When RSSI is selected in the Aging out drop-down menu, select the percentage of RSSI here. When the RSSI of wireless
clients is lower than the specified percentage, the device disconnects the wireless clients.
Data Rate Threshold: When Data Rate is selected in the Aging out drop-down menu, select the threshold of data rate here. When the data
rate of wireless clients is lower than the specified number, the device disconnects the wireless clients.
ACL RSSI: Use the drop-down menu to Enable the function. When enabled, the device denies the connection request from the
wireless clients with the RSSI lower than the specified threshold below.
ACL RSSI Threshold:
Set the ACL RSSI Threshold.
D-Link DAP-2695 User Manual 26