Table of Contents
Advertisement
Zone 2—Continued
3
To turn off Zone 2, press the
[ZONE 2] button, followed by the
[ON/STANDBY] button.
Note:
• To control Zone 2, you must press the remote
controller's [ZONE 2] button first.
Adjusting the Volume of Zone 2
1
On the remote controller, press
the [ZONE 2] Remote Mode
button, and then use the VOL
[
On the receiver, press the [ZONE
2] button, and then use the Up
and Down [
Adjusting the Balance of Zone 2
1
On the receiver, press the [ZONE
2] button.
2
Press the receiver's [TONE]
button repeatedly to select
Balance.
38
]/[
] buttons.
]/[
] buttons.
3
Use the Up and Down [
buttons to adjust the balance.
You can adjust the balance from 0 in the
center to +12 dB to the right or +12 dB
to the left in 2 dB steps.
Muting Zone 2
On the remote controller, press
the [ZONE 2] Remote Mode
button, and then press the
[MUTING] button.
To unmute a zone, on the remote
controller, press the [ZONE 2]
Remote Mode button, and then
press the [MUTING] button again.
Adjusting the Tone of Zone 2
1
On the receiver, press the [ZONE
2] button.
2
Press the receiver's [TONE]
button repeatedly to select Bass
or Treble.
3
Use the Up and Down [
buttons to adjust the bass or
treble.
You can boost or cut the Bass or Treble
from -12 to +12 in 2 steps.
Notes:
• Zone 2 can also be unmuted by adjusting the volume.
• The Zone 2 level, balance, and tone functions have no
effect on the ZONE 2 PRE OUT when the Zone 2 Out
setting is set to Fixed (page 36).
]/[
]
]/[
]
Hide quick links:
Advertisement
Table of Contents
