Pausing During Play (Pause); Preamplifier Output - Bosch Dover USB40/80 Operating And Installation Instructions

46 | en
Exiting RPT
To stop repeating the track,
f Press the 2 : button repeatedly until
"RPT OFF" appears in the display.
The RPT symbol on the display disappears.

Pausing during play (PAUSE)

f Press the 1 : button.
The display shows "PAUSE".
Continuing after the pause
f Press the 1 : button during the pause.
Play continues.
7 620 000 120 - 123 | 10.2010
USB operation | Preamplifier output

Preamplifier output

You can connect an amplifier to the device
in order to operate a subwoofer loudspeaker.
To do so, the amplifier must be connected to
the rear side of the device (compartment C1).
The level of the subwoofer can be adjusted in
the Audio menu:
f Press the AUD 9 button to open the
menu.
f Press the AUD 9 button repeatedly until
"SUBWF" appears on the display along
with the current setting.
f Turn the volume controller 1 to the left
or right in order to set the level to between
0 and 7.
In order to leave the menu
f Press the AUD 9 button, repeatedly if
necessary.
Note:
When the tone settings are reset (see
the "Resetting the tone" section in the
"Sound" chapter), the level of the
subwoofer is set to "0".
Robert Bosch Car Multimedia GmbH