Functional Specification - Kenwood DDX5032 Service Manual

DDX5022/5022Y/5032/5032M/512/52RY
DNX5120/512EX/5220/5220BT
3.11 Auto Adjust screen
Carry out the automatic adjustment of Chroma / Mstar.
The contents displayed on the Auto Adjust screen are
shown in Figure 3.11.
Note: Refer to the hardware service documents for the
equipment to connect to the set.
Auto Adjust
Auto Adjust
Start
Cancel
Figure 3.11 Auto Adjust screen
Key Specifi cation
Auto Adjust Start : Start automatic adjustment.
Cancel, Return : Transfer to Test Mode Main screen
3.12 Inverter screen
Change the inverter frequency.
The Inverter screen is shown in Figure 3.12.
Inverter Check
Low
Figure 3.12 Inverter screen
Key Specifi cation
Low : Set the inverter frequency at Low level.
High : Set the inverter frequency at High level.
Return : Transfer to Test Mode Main screen
3.13 NAVI screen
Check the system in preparation for updating the Naviga-
tion MAP data.
The NAVI screen is shown in Figure 3.13.
NAVI MAP Update Check
NAVI Check
Cancel
Figure 3.13 NAVI screen
20
TEST MODE
Auto Adjust
Adjust OK/NG
Return
High
Return
NAVI MAP Update Check
NAVI OK/NG
Return
Key Specifi cation
NAVI Check : Access Navigation to update NAVI MAP.
Cancel : Transfer to Test Mode Main screen
Return : Re-start the system in the normal mode.
∗ Note that the screen will be blanked for a moment after
the NAVI Check is executed.
∗ Regardless of the result (OK or NG) of the check, the
system clears the Test mode after this check and it is re-
started in the normal mode
4 Functional specifi cation
This section describes the test mode specifi cation in each
function.
4.1 Display
In the Test mode, the display is exclusively used for the test
but screens for Source Control, Audio Control and Setup
are same as those that are normally used.
The system shows the touch position (+). However, it is not
shown in the Touch Adjust screen (under adjustment).
4.2 Key
The hard key specifi cation is listed in Table 4.2. (Note that
the keys that are not listed in the table have conventional
functions.)
Table 4.2 Hard key
Key
Auto Motor driver
Press and hold DVD audio and
[NAV] key video switching
(Reference)
Mode Description
Test Mode OPEN+SRC+Reset
SRC+VOL.DW+
Span switching
Reset
DC Offset/Service/ EJECT+AUTO+
Memory Other Clear Reset
EJECT+VOL.DW+
Retailer mode: ON
Reset
Retailer mode: OFF SRC+Reset
RDS test drive mode EJECT+ATT+Reset
4.3 Remote controller
The remote controller key specifi cation is listed in Table 4.3.
(Note that the keys that are not listed in the table have con-
KVT DDX/DNX
-
DVD audio and
video switching
KVT DDX/DNX
SRC+ATT+Reset
NAV+EJECT+Reset
SRC+FUNC+Reset
EJECT+FUNC+
Reset
SRC+Reset
EJECT+ATT+Reset