Trailer Attachment - InStep QUICK N EZ User Manual

Trailer Attachment

The following section provides instructions for
attaching the trailer to a bicycle with rear hub nuts
or quick release.
Note: Remove the coupler plate and tab washer
from the end of the tow bar before proceeding.
Use of the trailer without the safety strap attached
to the bicycle may result in serious injury or death.
Always attach the safety strap to the bicycle when
using the trailer.
1.
Using a wrench, remove the hub nut and
washer from the bicycle's back wheel.
Washer
Hub nut
2.
Place the tab washer on the axle. Fit the tab
into the slot on the bicycle frame dropout.
Slot
Tab
Axle slot
Tab
washer
If your bike frame doesn't have a slot in the
Note:
drop out, rotate the tab to fit in the axle slot.
8
WARNING!
3.
Place the coupler plate on the axle, in a
vertical position and the large hole down.
Align the pegs on the back of the plate with
the holes in the tab washer.
Coupler
pegs
Coupler
plate large
hole
4.
Place the hub nut and washer back on the axle
and tighten.
Washer
Hub nut
Coupler
plate