Connection To The Network; System Requirements; Required Equipment Preparation - Hitachi CP-WU8451 User Manual

1. Connection to the network

1.1 System requirements

1.1.1 Required equipment preparation

The following equipments are required to connect the projector to your computer
through the network.
■ Common The projector: 1 unit,
■ Depending on how you want to connect
1) For the wired connection *1
LAN cable (CAT-5 or greater): 1 piece
2) For the wireless connection *2
- Projector side
IEEE802.11b/g/n USB wireless adapter (option : USB-WL-11N): 1 unit
- Computer side
IEEE802.11b/g/n wireless LAN equipment: 1 unit for each *4
*1: The system for using the network function of the projector requires
communication environment conforming 100Base-TX or 10Base-T.
*2: An access point is required when the wireless LAN connection is used as
Infrastructure mode.
*3: Available encryption methods are as follows. This product cannot be connected
to the wireless network using other encryption method.
WPA2-PSK (AES)
WPA2-PSK (TKIP)
WPA-PSK (AES)
WPA-PSK (TKIP)
WEP 128bit
WEP 64bit
*4: Depending on the type of wireless network device and computer you are using,
the projector may not be able to communicate properly with your computer,
even if the computer is equipped with a built-in wireless LAN function.
To eliminate communication problems, please use a Wi-Fi certified wireless
network device.
1. Connection to the network
Computer: minimum 1 set
5