Cable Management - Sony FWD-40LX1 Operating Instructions Manual

Cable management

The display has the cable covers on its back. Before
connecting the cables to the display, pull the cable
covers to open. After connecting the cables to the
display, close the cable covers.
Using the cable holders
You can bundle the cables with the supplied cable
holders (×6 for the FWD-40LX1 and ×4 for the FWD-
32LX1R). Choose three successive blank parts of the
air vents for the cable holder on the FWD-40LX1.
FWD-32LX1R
Cable holder
Inset the cable holder into
the hole on the unit and
rotate it about 90 degrees.
1
2
3
Cable cover
Speaker cord holder
(Only for the FWD-
40LX1)
Choose six out of eight holes on the FWD-32LX1R.
Attach the cable holders in the illustration below.
When you connect the speakers SS-SP40FW (not
supplied), route the speaker cords through the speaker
cord holders on the rear of the display unit. (Only for
the FWD-40LX1)
Rear
Connections
Cable cover (bottom)
FWD-40LX1
Cable holder
Press the hinge part to
open the hooking nails.
Insert the cable holder
into the slits.
1
2
15
(GB)