Install The Microwave Oven; Install Trim Kit Frame - Kenmore 405.24303410 Installation Instruction

5. Using a 7/64" drill bit, drill pilot holes into the three hole marks
shown in the figure above.
6. Realign and install the bottom duct with three short screws.
7. Using a 7/64" drill bit, drill pilot holes through the four bottom
duct flange mounting holes on the bottom front facing of
the cutout/cabinet opening.
A
A. Bottom duct flange
B. Mounting holes

Install the Microwave Oven

1. Carefully return microwave oven to its upright position.
2. Position microwave oven near cutout opening.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
3. Plug in microwave oven.
4. Align the rails with the rail guides on the bottom duct.
A. Rail guides
B. Rails
B
A
B
5. Slide the microwave oven back and into place. The mounting
holes of the rail flanges and bottom duct flange will align
against the bottom front facing of the cutout/cabinet opening.
6. Secure the microwave oven to the cutout/cabinet by installing
four short screws into the mounting holes.

Install Trim Kit Frame

1. Position trim kit frame over the opening so that the lower tabs
rest on the cutout floor, as shown.
A
EN-5
A
B
A. Mounting holes
B. Short screws (4)
B
C
A. Front of trim kit frame
B. Tabs (upper and lower)
C. Cutout/cabinet floor