Error Messages - One for All Home Producer URC 9800 User Manual

50
TROUBLESHOOTING (cont.)
Problem: Solution
CH +/- and PREV Due to RCA design (1983-
CH not working for 1987), only the original
your RCA TV? remote control will operate
these functions.
Problems changing If your original remote control
channels? required an ENTER keystroke
when changing channels,
press the ENTER key on the
Home Producer after you
enter the channel number.
The red light blinks Make sure you are aiming
when you press a your Home Producer at your
key but you receive home entertainment compo-
no response from nent and that you are within
your home entertain- 15 feet before using your
ment component? remote control.
Your audio compo- Some audio components may
nents turn on and off need both a Tuner/Receiver
and control volume code and an Audio Amplifier
but do not change code to control all of the fea-
preset channels? tures of your audio component.
Your DSS satellite The codes listed in this man-
receiver does not ual are set up to operate your
respond to the DSS receiver on the 1st or
codes listed in the 2nd addresses only. Make
manual? sure the DSS Receiver can
be operated with an infrared
remote control and is not set
up to only receive Radio
Frequency.
The Home Producer Some Bang & Olufsen prod-
is not operating your ucts, as well as some other
Bang & Olufsen manufacturer's equipment
equipment? operate at a frequency higher
than 100 kHz and will not
work with the Home Producer.

ERROR MESSAGES

Error Meaning
MEM FULL Maximum memory capacity
has been reached.
BATTERY LO Replace batteries with four
new "AAA" Alkaline batteries.
TOO LONG Macro sequence being entered
exceeds 15 keystrokes.
LIST END You have reached the end of
all valid codes using the
Step-N-Set sequence.
INVALID Displayed when trying to
specify a key that is not valid
for the sequence being
entered. For example, when
selecting a Device Key (e.g.,
TV) for a Macro sequence.
NOT FOUND Displayed when you enter in
a code that is not valid for the
device being programmed.
ERROR Displayed when an error has
occurred in the learning
sequence.
1-330-593-3325
Consumer Help Line:
http://www.hudsonag.com
World Wide Web:
Help@hudsonag.com
E-mail help:
51