45
SETTING UP AND USING THE IR/RF
COMMAND CENTER
The Home Producer comes with an IR/RF
Command Center which receives Radio Frequency
(RF) signals from your Home Producer, anywhere in
your home, up to 100 feet away. The Command
Center then converts the RF signal into an Infrared
signal to control your home theater components. To
setup the Command Center:
1
Find a location approximately 8 feet in front
of your home theater components.
NOTE: The location should have access to both your equipment
(line-of-sight) and an outlet to plug in the Command Center.
2
Plug in the Command Center’s Power Cord
and raise the telescoping antenna.
Telescoping Antenna
IR Lens
3
Position the Command Center so the black
IR lens is aimed at your home theater com-
ponents.
4
Test the Command Center by pressing the
POWER key on the Home Producer. Your
components should operate from any room
in your home, up to 100 feet away.
NOTE: The Home Producer transmits both an IR and an RF sig-
nal simultaneously. When you are testing the Command Center
with Home Producer, make sure that the remote control is not
aimed at your equipment.