Makita HM0871C Instruction Manual page 7

This tool requires no hourly or daily lubrication because
it has a grease-packed lubrication system. It should be
lubricated every time the carbon brushes are replaced.
Send the complete tool to Makita Authorized Service
Center for this lubrication service.
Fig.14
Run the tool for several minutes to warm it up. Switch off
and unplug the tool.
Loosen the four screws and remove the handle. Note
that the top screws are different from other screws.
Fig.15
Disconnect the connector by pulling them.
Fig.16
Loosen the four screws on crank cap and remove the
crank cap cover.
Fig.17
Wipe out the old grease inside and replace with a fresh
grease (30 g). Use only Makita genuine hammer grease
(optional accessory). Filling with more than the specified
amount of grease (approx. 30 g) can cause faulty
hammering action or tool failure. Fill only with the
specified amount of grease.
CAUTION:
Be careful not to damage the connector or lead
•
wires especially when wiping out the old grease.
To reassemble the tool, follow the disassembling
procedure in reverse.
CAUTION:
Do not tighten the crank cap excessively. It is made
•
of resin and is subject to breakage.
Be careful not to damage the connector or lead
•
wires especially when installing the handle.
Fig.18
Connect the connector firmly and then reinstall the
handle.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized Service Centers, always using Makita
replacement parts.
ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
or attachments
Only use accessory or
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Bull point (SDS-max)
•
Cold chisel (SDS-max)
•
Scaling chisel (SDS-max)
•
Clay spade (SDS-max)
•
Bit grease
•
Safety goggles
•
Hammer grease
•
Plastic carrying case
•
are
7