2.1 Installation Instructions
The AP 6522M Access Point mounts either on a wall (with customer supplied M4 x 25 pan head screws and wall
anchor - or equivalent) or on a suspended ceiling T-bar. An AP 6522M is not designed for mounting on a desk.
To prepare for the installation:
1. Match the model number on the purchase order with the model numbers in the packing list and on the
case of the Access Point.
2. Verify the contents of the box include the intended AP 6522M Access Point, and the included hardware
matches the package contents on page 5.
3. Review site survey and network analysis reports to determine the location and mounting position for the
4. Connect a CAT-5 or better Ethernet cable to a compatible 802.3af power source and run the cable to the
installation site. Ensure there is sufficient slack on the cable to perform the installation steps.
Dual 802.11n radio AP 6522M. Plastic enclosure with internal antennas.
For use in Japan only.
In the above part numbers,
wide model, whereas "US" defines the model as only legally deployable
in the United States.
When operating in a Gigabit Ethernet environment, CAT-5e or CAT-6 cable
is recommended for Gigabit operation.
country code of "WR" represents a world
AP 6522M Access Point